How to Stop Hitting Fat Iron Shots: A Ball-First Drill
Last updated: November 17, 2026
Piece: Approach shots | Level: Break 90 | 5-minute read | Part of the Path 2 Par blueprint
A fat shot hits the ground before the ball, which means the bottom of your swing is behind the ball. The ball comes up short and weak, and the club digs in. To fix it, favor your lead foot at address, keep your weight moving forward on the way down, and strike the ball first so the divot starts just after it.
The leak: the low point is behind the ball
A fat shot, also called a chunk or a duff, costs you distance and often leaves the ball in the front of the green or short of it. It usually comes from one of three habits: your weight hangs back on your trail foot, you try to scoop the ball into the air with your hands, or the ball sits too far forward in your stance for the club you are hitting.
The fix: three steps
- Set up for a downward strike. Play mid-irons near the middle of your stance, and set slightly more weight on your lead foot, about 55 to 60 percent, so your swing bottoms out in front of the ball. Check the chart in Golf Ball Position: Where to Play Every Club.
- Keep your weight moving forward. Start the downswing by moving your lower body toward the target, so your chest is over or just ahead of the ball at impact and your hands lead the clubhead.
- Aim for a spot in front of the ball. Pick a spot on the grass about an inch in front of the ball and aim to brush it. Your divot should be shallow and start at or just after the ball.
The drill: the headcover drill
Place a headcover or a folded towel about two inches behind the ball, on the side away from the target. Hit the ball with a 7-iron without touching the headcover. If you hit it, your swing is bottoming out behind the ball. Hit ten balls. Success: at least 8 of 10 swings miss the headcover and strike the ball first.
Your 7-day game plan
- Day 1: check your weight at address: a little more on the lead foot, not on your heels or toes.
- Day 2: make 20 slow swings brushing a spot on the grass in front of an imaginary ball.
- Day 3: run the headcover drill with ten balls.
- Day 4: repeat the drill with a wedge and a longer iron.
- Day 5: check your ball position for each club against the chart.
- Day 6: play nine holes and pick a spot in front of the ball on every iron shot.
- Day 7: look at your divots on the range: they should start at or after where the ball was.
Your rule for the next round
On every iron shot, pick a spot an inch in front of the ball and take your divot there.
The measure
Count the fat shots per round: iron shots that dig in behind the ball and finish well short. Record a baseline over two rounds, then aim to cut that number in half within four weeks. That is a target, not a guarantee.
Next piece on the path
Once you strike the ball first, learn to control your distance with How to Control Wedge Distance: The Clock Drill. If your misses go thin instead, read How to Stop Topping the Golf Ball, and keep the range sessions structured with Driving Range Practice: A 30-Minute Plan for High-Handicap Golfers. See the full Path 2 Par blueprint.
Common questions
Why do I hit fat iron shots?
The bottom of your swing is behind the ball. The most common reasons are weight staying on the trail foot, scooping the ball with your hands, and a ball position that is too far forward for the club.
Why do I hit fat wedge shots?
Often it is a slow-down into the ball, because a short shot feels like it needs a gentle swing. Keep a steady tempo, shorten the swing instead of slowing it, and keep your weight moving toward the target.
How deep should my divot be?
Shallow, and starting at or just after where the ball was. A deep divot behind the ball’s position is the sign of a fat shot.
Does ball position cause fat shots?
It can. If the ball is too far forward for the club, the club reaches the bottom of its arc before it gets to the ball. Move it back toward the middle for short and mid irons and recheck.
